This is a heavy duty Superior Engineering Brake Proportioning Valve Bracket Suitable For Toyota Landcruiser 80/105 Series with a 3" inch lift.
When a lift Kit is fitted to a 4wd it is mandatory to fit a correct size proportioning bracket.
4WD's have a "Brake Bias" or proportioning valve that is fitted to the braking system, The purpose of this is to allow the correct proportion of brakes between the front and the rear brakes.
If a vehicle has a lift fitted, the Proportioning valve / Brake Bias will think that there is no load on the rear end so the brakes will not perform correctly for the vehicle and this may cause a vehicle to lose control and crash.
As a general rule you must lift the proportioning bracket / Brake Bias Bracket mounting point up the same amount as the vehicle is lifted over standard "factory" height.
So if you have a 3 inch lift you should lift your proportioning valve / Brake Bias up approx 3 inches.
Superior Engineering manufactures and sells these inexpensive Proportioning brackets to enable your brakes to perform at there peak.
It is also recommended to fit Braided brake lines if you have fitted larger tires or raised the vehicle.
The Superior Engineering Proportioning Valve Brackets / Brake Bias simply Bolt on with just a couple of spanners!
Why would you risk your safety by not fitting one of these?
Superior Engineering is not sponsored, approved, affiliated or otherwise associated with any genuine or original parts manufacturer, distributor or dealer.
Identification and Guidance Only – Photos are for identification purposes only and may be of either genuine or non-genuine parts.
All manufacturers names, symbols and descriptions on this website are used for reference purposes only, and it is not implied that any units or parts listed is the product of these manufacturers.
Original Equipment Manufacturer "OEM" part/reference numbers are listed for information/reference purposes only. Trademarks identifying these parts are those of each OEM and are the property of their owners and are not used, or authorized for use, by Superior Engineering. Cross-referenced parts from the Original Equipment Manufacturer "OEM" are listed for information purposes only.
Superior Engineering has no associations and/or claims to be associated with OEM Vehicle Manufacturers and their Companies worldwide. Any implied associations are purely coincidental and are not inferred. Superior Engineering is a supplier of fully interchangeable non-genuine spare parts (alternatives) for equipment produced by manufacturers using in accordance with law OEM Vehicle Manufacturers and their products, i.e. suspension parts, steering components, manufactured items, vehicle accessories etc. Alternative spare parts produced by Superior Engineering are manufactured according own technological documentation developed with the use of reverse engineering.
|Lift Height||3 inch|